Find and download historical manuals below. Carbon Knockout Owner’s Manual Medalist 38 Owner’s Manual. 2017 Catalog Edge SB-1 Owner’s Manual Edge Sonar Owner’s Manual Atomic Owner’s Manual. 2016 Catalog 2016 Diamond Owner’s Manual Deploy SB Owner’s Manual Prism Owner’s Manual. 2015 Catalog 2015 Limb. ![]() Tafsir misbah quraish shihab. DIAMOND TESTER INSTRUCTION MANUALS BUY NOW: CLICK ON THE PICTURE Instruction manuals for diamond testers, combination testers, multi testers, diamond-Moissanite testers. CONTENTS MODEL DT5 MODEL DT (marked DT on back of tester) MODEL DT (marked Thermal Tester) TROUBLESHOOTING (all diamond testers) MOISSANITE TESTER DN1 COMBINED TESTER BUYING TIPS MODEL: DT-5 PREPARATION Supplied with PP3 battery. To change battery, slide battery cover in direction of arrow, pull old battery out gently, do not keep pulling until you pull the wires out. The stone holder is for loose (un-mounted) stones, since you would not be able to hold them in your fingers. This model is particularly good for coping with extremes of temperature. Unlike other models, it has been calibrated for Northern Europe where outdoor markets and unheated halls can be cold. However, avoid extremes of temperature between the stone and the tester. For instance, If you are working in the warm and a customer brings in a stone that has been stored in the freezing cold, or if you take a stone from a hot window display. Wait five minutes for the stone and tester to reach the same temperature. INSTRUCTIONS FOR USE Turn the SENSITIVITY knob just enough for it to click. The BATTERY OK light will light up and the segments will flash briefly. ![]() Then wait for the READY light (20 to 30 seconds). Gently remove the rubber protective cap from test tip (remember to replace it after use). Turn the SENSITIVITY knob until some of the segments are lit (usually the four red segments, see SETTING THE SENSITIVITY below). Press test tip firmly onto the top of the diamond at right angles. Do not attempt to scratch the stone or you will break or bend the test-tip. Make sure you are touching (with your hand) the metal plate on the back, then if you miss the stone and touch the setting by accident an alarm will sound. • Lights remain static (nothing happens) = not diamond • Lights up slowly, doesn't register 'diamond' = not diamond (probably ruby or sapphire) • Lights up past Segment 9 (three blue lights and bleeps) = diamond Before the next test you must wait for the READY light. Repeatedly testing the same stone (especially a small stone) warms it until, eventually, a diamond will no longer read DIAMOND. Wait at least two minutes for the stone to cool down. SETTING THE SENSITIVITY Turn the knob to light up the segments, set the starting-number like this: METHOD 1: Look at the chart on the back of the diamond tester. The range of sizes and the temperatures are not critical, use them merely as a guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |